This video will go over how to upgrade the ZPU to version 1.4.7 and the TaZer Firmware to Version 2.2.7 – 110216. This adds some great new features like the ability to Map the Aux buttons on the wheel, custom light shows with more options and the ability to save and load files. This opens up options to SHARE your favorite light shows with friends.
How to Jack up the car, where to put the jack stands, perform the oil change and Oil Life reset. This video is specific to the Scat Pack 6.4L or 392 Cu In engine, I would allow for an hour to complete the job 2 if you have not done this before.
Checking your Oil
A good reference is from the bottom of the safe zone scoring to the top is 1 quart of oil. The best time to check your oil is when you car has reached operating temperature then had been off for 5 minutes and is on level ground. I check mine every time I get gas, since I don’t usually wait 5 minutes I account for a little missing oil that has not drained out of the engine. Regardless the oil should never be above or below the safe zone scoring on your short throw dipstick
I Paid full retail price for all the gear below, but I’m trying something different with my links. I signed up for the amazon Affiliate program, if you make a purchase using my links below a small % goes to WorkPlayDrive at no additional cost to you. “WorkPlayDrive is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to amazon.com.”
SUPPLIES
Jack & Jack Stands appropriately rated for this 4500 lb car
2ea 10” length 2 x 4 (lumber) if your jack is not low profile
The Jack pad I picked up slides nicely along the pinch weld and sticks in place to keep the jack from destroying my rocker trim.
For the first oil change the factory Sasquatch installs the filter, it’s near impossible for a mortal man to remove without the help of a large adjustable 3/8 drive socket type filter wrench that can handle the behemoth 3.8” filter. I recommend socket type because there is not much room along the sides of the filter.
The oil I have been using Pennzoil Ultra Platinum Full Synthetic Motor Oil 0w-40 as it’s the only oil that I found the meets (MS-12633) and can be delivered via Amazon subscribe and save. Same with the Royal Purple filter, It’s a good brand, purple and eligible for Amazon Subscribe and save.
If you have a blacktop driveway its best to put a metal or plywood base under your jack stands to the pressure is distributed evenly Jackstands tend to sink in sometimes.
Disclaimer: Use properly rated jack stand NEVER get under you car without them.If you don’t know your way around the engine bay or how to properly use a jack or tools, please have someone who does assist you. While you did not see me using a torque wrench I want to note it’s always best to follow manufacturers service manual to make sure everything is reinstalled to proper tightness. With this video I hope to encourage someone like me who does not want other people working on their car to do it themselves.
Get your kit here luxeautoconcepts.net (affiliate Link)
Use Code workplaydrive
15% off your order
(affiliate) In addition to your discount your purchases go towards Luxe product I give away to film install videos testing and upcoming projects which I will share. Thanks for your support!
Don’t forget to like and subscribe for more videos
*~*~*~*~*~*~* Folow us *~*~*~*~*~*~* http://www.instagram.com/workplaydrive https://www.facebook.com/workplaydrive392 http://twitter.com/WorkPlayDrive
**When using the code “workplaydrive” a % of the sale will be held so I can use towards free product for future contests and giveaways. I have requested specifically NOT to be paid for any purchases. We at workplaydrive (which is just me at the moment) are NOT in it for the money, we want to help, share experiences and our thoughts with you or loyal subscribers and followers. I’d love to be famous, maybe you guys can help with that… More info can be found here http://www.workplaydrive.com/product-…
Enjoy
WorkPlayDrive Family
—————– If you are reading this #Becausegiraffe
This video will go over how to install the AV Kit for the TaZer. You can grab one from our affiliate link zAutomotive.com if you would like to help the channel
The TaZer which is used to unlock these inputs and the AV kit can be purchased from here: zAutomotive.com
For use with a Tazer, this wire kit is required to feed video and audio into your factory Uconnect 8.4″ screen. You can connect two independent sources – a DVD player, media player, front or side cameras, wifi mirror device (to mirror your phone’s screen), etc. Stereo RCA jacks for audio input, using the “CD” input that the Tazer will unlock. Two independent RCA video inputs – the Tazer allows you to use either input on demand at any speed. Installation of this harness involves removal of the dash trim (plastic trim tools included), unscrewing and removal of the radio, then inserting the pins of the harness into the appropriate slots on the factory radio harness connector.
You can then plug in your camera or other video/audio sources into this harness.
After 2 Months of daily use I can honestly say that ProClip is officially WorkPlayDrive Approved! No BS just one good solid mount. I happy to say at the time of posting this video we now have another ProClip for my wife’s Jeep.
Detailed comparison of the Luxe Auto Concepts Dark Smoke, light Smoke Headlight Tint kit along with a No tint reference.
Get your kit here luxeautoconcepts.net (affiliate Link)
Use Code workplaydrive
15% off your order
(affiliate) In addition to your discount your purchases go towards Luxe product I give away to film install videos testing and upcoming projects which I will share. Thanks for your support!
This video will go over how to enable the Shift Light in a 2015 Challenger Scat Pack using the Z Automotive TaZer from zAutomotive.com This can be applied to most model CHallengers and Chargers. To se if your car is eligible please see the F.A.Q. zautomotive.com–FAQ
***Note you must have access to the Launch control screen in order to enable and set the shift light settings.
I’m also noticing on my 2015 Manual Scat Pack that the shift light does not sense the gears so in first, second, etc. the shift light is on for all set points. Please comment if you have the same issue….
Don’t forget to like and subscribe for more videos
Get the Tazer here: zAutomotive.com
*~*~*~*~*~*~* Folow us *~*~*~*~*~*~* Instagram Facebook/Workplaydrive392 Twitter
—————– If you are reading this #Becausegiraffe
–**–**–**–**–**–** Music Track by **–**–**–**–**–**–
Download Hindsight by Frakture for free, and use it in your monetized YouTube videos without receiving a copyright claim.
Sharing my love for Luxe with the crew. High speed video of luxe side marker install on a Charger Hellcat and Challenger Black top in Go Mango. Headlight install on the WorkPlayDrive Challenger.
**DISCOUNT CODE: workplaydrive
$5 off any order over $20
Get it here: Luxeautoconcepts.net
Don’t forget to like and subscribe for more videos
**When using the code “workplaydrive” a % of the sale will be held so I can use towards free product for future contests and giveaways. I have requested specifically NOT to be paid for any purchases. We at workplaydrive (which is just me at the moment) are NOT in it for the money, we want to help, share experiences and our thoughts with you or loyal subscribers and followers. I’d love to be famous, maybe you guys can help with that… More info can be found here http://www.workplaydrive.com/product-review-process/
Enjoy
WorkPlayDrive Family
—————– If you are reading this #Becausegiraffe
–**–**–**–**–**–** Music Track by **–**–**–**–**–**–
This video will go over how to change your Challenger Splash screen using the Z Automotive TaZer from http://zautotech.com
Options
Hellcat
Scat Pack
Shaker
Challenger
Why didn’t my Scat Pack with the Scat Pack Appearance Group (SPAG) not have the Bee Spash screen and the Seats?
This is what I could find on the subject (thanks to Challengertalk.com)
************************************* (link to Challengertalk.com)
Case Number: S1408000421
Release Date: 07/23/2015
Symptom/Vehicle Issue:
Instrument Cluster Does Not Display The Scat Pack Bee, Scat Pack Equipped Vehicle
Discussion:
Scat Pack vehicle’s that are built prior to build date 4/21/15 will not have the Bee in cluster display.
The Bee in cluster implementation was added to vehicles built 4/21/15 and later with an order date
post 3/2/15 with the interior/exterior SCAT PACK APPEARANCE GROUP – ASA
Note: This feature and its components are available only at the time of the original order. >>>>>>> No available dealer service options are available to add this appearance group.
*********************************
(link to Challengertalk.com)
They had issues meeting the demand with the forged wheels so they created 2 Scat PacK Appearance Groups (SPAG) The Scat Pack Appearance Package (ARH – $1,995) was replaced with the Scat Pack Stripe Group (ASB – $995) then allowing to order the $1,000 light weight Wheel option when available. It appears I got the SPAG ARH. The ASA I am assuming is the one with the Scat Bees in the seats.
ARH
• LMP – HID headlamps
• MFF – Black Grille with Bezel split Grille
• M91 – Scat Pack Stripe
• XJD – Satin Black Fuel Filler Door
• WRT – 20×9-inch Forged Alum Wheels
ASB
• LMP – HID headlamps
• MFF – Black Grille w/ Bezel split Grille
• M91 – Scat Pack Stripe
• XJD – Satin Black Fuel Filler Door
ASA
TBA, mid-February production launch (adds interior features)
Don’t forget to like and subscribe for more videos
Get the Tazer here: zautotech.com
