This video will go over how to enable the Shift Light in a 2015 Challenger Scat Pack using the Z Automotive TaZer from zAutomotive.com This can be applied to most model CHallengers and Chargers. To se if your car is eligible please see the F.A.Q. zautomotive.com–FAQ
***Note you must have access to the Launch control screen in order to enable and set the shift light settings.
I’m also noticing on my 2015 Manual Scat Pack that the shift light does not sense the gears so in first, second, etc. the shift light is on for all set points. Please comment if you have the same issue….
Don’t forget to like and subscribe for more videos
Get the Tazer here: zAutomotive.com
The looks of “you don’t belong here” were flying at the dealership as I grumbled in. While I waited for my pops to pick up the battery I setup my GoPro and some other gear and started working on ways to get great driving footage, while recording the exhaust and eliminating wind noise.
I worked out the wind noise issue, I just need to work on the clipping when on the throttle hard. I’ll give it another run tomorrow, but this footage was too good to waste.
If you have any recording suggestion please share.
A few weeks back in one of my blog posts I went into detail on how i fixed my “behind the wheel issues” for about $10.00 a wheel. And now for an additional $10 per wheel we’re going to finish the job with G2 caliper paint.
blog Post http://goo.gl/pKIwK4
— Coupon Code workplaydrive will get you 7% off all items including Custom Factory matched paint. through 3/31/2017
**Note: Use of this code will eventually earn us another free kit for a future give away to our subscribers. (1 free kit for every 10 sold)
Note: the standard Kits on Amazon are about $10 cheaper so buy from there
You will need a few other things to do this job.
• latex gloves
• safety goggles
• masking tape
• wire brush
• 800 grit sand paper (if your calipers are rusted)
• lint free microfiber or shop towels to wipe up mistakes.